Key takeaways
- A plain ETH transfer always uses 21,000 units of gas, while a Uniswap swap uses about 184,500, so swaps cost roughly nine times more at the same gas price.
- Each unit of gas costs the protocol's base fee, which is burned, plus an optional priority fee that goes to the validator, and the base fee can move at most 12.5% per block.
- On Etherscan on November 14, 2026, a base fee of 0.078 gwei put a simple ETH transfer at about $0.003, while the same math at a spiked 202.7 gwei base fee puts a swap above $70.
In this story 8 sections
- Gwei: the unit behind every gas price
- 21,000 gas and why other actions cost more
- Base fee and priority fee: the two halves of the price
- 12.5% per block: how fast fees can climb
- Max fee and the refund you get back
- Failed transactions still cost gas
- A worked example with today's numbers and a busy day
- Ways to pay less
A gas fee is what you pay the Ethereum network to process your transaction, and right now it can be a fraction of a cent or, on a frantic day, tens of dollars. So what is a gas fee, exactly? It is the amount of computing work your transaction needs (measured in "gas") multiplied by the going price per unit of that work, paid in ETH. Here are the numbers that decide your cost.
- 1 gwei is one billionth of an ETH (0.000000001 ETH), and gas prices are quoted in gwei.
- 21,000 gas is what a plain ETH transfer uses.
- 65,000 gas is a typical ERC-20 token send, about 84,900 for an NFT transfer and about 184,500 for a Uniswap swap, per ethereum.org.
- Base fee plus priority fee is the price per unit of gas you actually pay.
- 12.5% is the most the base fee can rise or fall from one block to the next.
- About 12 seconds is how often a new block, and a new base fee, arrives.
- 0.078 gwei was the base fee on Etherscan's gas tracker on the morning of November 14, 2026, with ETH at about $1,894.
Gwei: the unit behind every gas price
Quoting fees in ETH would mean writing a lot of zeros, so wallets and trackers use gwei. According to ethereum.org's gas documentation, one gwei equals one billionth of an ETH, and one gwei equals one billion wei, the smallest unit of ETH.
When MetaMask, Trust Wallet or Coinbase Wallet shows you "0.08 gwei" or "25 gwei," that is the price per unit of gas, not your total. Your total depends on how many units your transaction burns through, which is the next number.
21,000 gas and why other actions cost more
Gas measures computational effort. Sending ETH from one address to another is the simplest thing the network does, and it always uses 21,000 units. Anything that touches a smart contract does more work, so it uses more gas.
The figures ethereum.org publishes give a sense of scale:
- Sending ETH: 21,000 gas
- Sending an ERC-20 token such as USDC: 65,000 gas
- Transferring an NFT: 84,904 gas
- Swapping on Uniswap: 184,523 gas
Those are typical amounts, and a complicated swap route can use more. The takeaway is that a token swap costs roughly nine times what a plain ETH send costs at the same gas price, so if fees feel high, the action you picked matters as much as the timing.
Bitcoin has no gas. People often search for a "gas fee in Bitcoin," but Bitcoin charges a transaction fee based on the size of your transaction in data, not on computation. Our guide on how to send bitcoin covers that side.
Base fee and priority fee: the two halves of the price
Since Ethereum's London upgrade (the change described in EIP-1559), the price per unit of gas has two parts.
The base fee is set by the protocol. It is the minimum a transaction must pay to be included in a block, and it is the same for everyone in that block. This part is burned, meaning the network destroys it rather than paying it to anyone.
The priority fee (often called the tip) goes to the validator who adds your transaction to a block. A bigger tip makes your transaction more attractive when blocks are crowded. When the network is quiet, the tip can be close to zero. On Etherscan's tracker on November 14, the "Standard" setting showed a priority fee of 0 and the "Rapid" setting showed 0.022 gwei.
The full formula, as ethereum.org puts it, is gas units used times (base fee plus priority fee). Coinbase's explainer on gas fees describes the same idea as gas limit times gas price, with tips added on top.
12.5% per block: how fast fees can climb
Each block has a target size, which is half its maximum gas limit. If a block is fuller than the target, the next block's base fee goes up. If it is emptier, the base fee goes down. The change is capped at 12.5% per block, and blocks come roughly every 12 seconds.
That cap sounds small, but it compounds. In ethereum.org's own example, a base fee of 100 gwei that meets six full blocks in a row climbs to 202.7 gwei, roughly double, in about a minute and a quarter. Keep going and it gets absurd fast, which is the point: the rising price pushes people to wait, demand drops, and the base fee falls again.
This is why fees spike during hyped NFT mints, sharp market moves or busy trading hours, then settle back. Ethereum.org notes that fees tend to be lower when North America is asleep, and that waiting even a few minutes can help.
Max fee and the refund you get back
Your wallet also sets a max fee, the most you are willing to pay per unit of gas. If the base fee plus tip turns out lower than your max, you get the difference back. You only pay what the block actually charged.
Separately, there is the gas limit, the most units your transaction may use. Ethereum.org gives a simple case: set a 50,000 gas limit on a plain transfer and the network uses 21,000, returning the other 29,000.
Failed transactions still cost gas
This catches a lot of people. Ethereum.org states that the fee is paid whether a transaction succeeds or fails. If a transaction runs out of gas partway through, all the gas you provided is used up and the changes are reversed, so you get nothing and still pay.
There is one exception. If your gas limit is too low for even the basic cost of the transaction, it is rejected before it ever gets into a block, and no gas is consumed.
A worked example with today's numbers and a busy day
Start with Etherscan's reading from November 14, 2026: a base fee of 0.078 gwei, a "Fast" tip of 0.001 gwei, and ETH at about $1,894.37.
Sending 0.5 ETH to a friend
- Gas used: 21,000
- Price per gas: 0.078 + 0.001 = 0.079 gwei
- Fee in gwei: 21,000 × 0.079 = 1,659 gwei
- Fee in ETH: 1,659 ÷ 1,000,000,000 = 0.000001659 ETH
- Fee in dollars: 0.000001659 × $1,894.37 ≈ $0.003
That matches the roughly $0.003 Etherscan showed for its Fast setting. A Uniswap swap at the same price works out to 184,523 × 0.079 = about 14,577 gwei, or around $0.03.
The same swap on a congested day
Now borrow ethereum.org's spike example, where the base fee climbs to 202.7 gwei, and add a 2 gwei tip.
- Price per gas: 202.7 + 2 = 204.7 gwei
- Fee in gwei: 184,523 × 204.7 ≈ 37,771,858 gwei
- Fee in ETH: about 0.0378 ETH
- Fee in dollars at $1,894.37: about $71.55
Same swap, same ETH price, and the cost went from three cents to more than $70. The units of work barely changed; the price per unit did.
Ways to pay less
- Check a tracker such as Etherscan's gas tracker before you send, and hold off for a few minutes if the base fee is elevated.
- Do contract heavy actions like swaps when the network is calm, since they use many more gas units.
- Consider a layer 2 network such as Arbitrum for everyday transfers. Ethereum.org notes layer 2 chains offer lower fees, though you will need to bridge funds and check that the person or app on the other end supports that network.
- Leave your wallet's suggested gas limit alone unless you know why you are changing it. Setting it too low can lead to a failed transaction that still costs you.
If you are still picking a wallet, our explainer on how crypto wallets work walks through the options, and Ethereum vs Solana compares typical fees across the two networks. For the bigger picture on what ETH itself is, see Ethereum explained, or browse more guides in our crypto section.
One last check before you hit confirm: look at the fee line in dollars, not just gwei. If it looks wrong for what you are doing, it is worth waiting a minute and looking again.
Sources
Share this story
Spotted an error? Tell us


